CALIFORNIA STAINLESS MFG.

SINK PLUMBING ASSEMBLIES & ACCESSORIES

SINK PLUMBING ASSEMBLIES

^{click here for more PLUMBING FIXTURES & WATER CONTROLS}

Have California Stainless install the highest quality chrome plated fixtures on your stainless or fiberglass sink. Choose the fixture and location to meet your specific requirements.
Backsplash height increased to 12" and width to 5" on Coved, Standard, or Temperature Sinks with order of Plumbing Assembly (Models PA1, PA2, PA3, or PA4). This provides faucet clearance, higher wall protection, and conceals plumbing connections, allowing sink to be against wall.
Wide Backsplash Returns, 5" deck, are ordered separately if individual deck faucets are ordered without Plumbing Assembly. (Models PA1, PA2, PA3, or PA4.)

Plumbing Assembly 1

(PA1) includes:
One concealed water temperature thermostatic control valve, one set checkstops, one 3½" dial thermometer, one Model WVB14 (shown) volume control valve with vacuum breaker for sink inlet swivel, one Model F62P faucet plumbed to temperature control valve, one Standpipe, one increased backsplash to 12" high and width to 5".

Plumbing Assembly 2

(PA2) includes:
Same as PA1 (above) plus one additional F62P (shown) faucet plumbed to temperature control, installed at opposite end.

Plumbing Assembly 3

(PA3) includes:
Same as PA2 (above) plus one 1201 (shown) Triple valve faucet plumbed to temperature control in center of sink.

Plumbing Assembly 4

(PA4) includes:
Same as PA2 Assembly, plus one 1200A (shown) Triple valve faucet with spray plumbed to temperature controls in center of sink.

Sebastian Fixtures For Sinks & Washers

Other options are available on the Sebastian Darkroom Products website. Please click here to be directed to SEBASTIAN PLUMBING FIXTURES & WATER CONTROLS

Click below to view more SINK PLUMBING ASSEMBLIES & ACCESSORIES

^{click here for more PLUMBING FIXTURES & WATER CONTROLS}

EMERGENCY EYE WASH

DECK MOUNT
EW-9702T11
Swivel deck mount eye wash
with dual spray heads and 12"
IPS ball valve with flap
handle. Inlet is 12" IPS.
EW-9702T11 -IN
Swivel deck mount eye wash
is installed in California
Stainless Sink. Deck on side
of sink, base, and backsplash
are increased 4".

DECK MOUNT
EW-5549T54
Eye wash with dual spray
heads, each have three
sprayers and are protected by
a polypropylene housing.
Stainless bowl is installed in
California Stainless counter top.

WALL MOUNT
EW-5535T6
Wall mount eye wash is
stainless construction with
two outlet heads. 12" IPS
inlet, 1 l14" IPS outlet.

FAUCET-MOUNT EYE WASH
EW-9792T42
Transform standard faucet into an eye wash station. To operate, turn on the
water at the faucet and Pull the valve knob. Chrome-plated brass dual-spray
arms and forward-angled heads. Furnished with a pair of dust covers to
prevent airborne contamination. The on-off valve has a 55/64" -27 female
thread (includes adapters for 1511 6" -27, 1311 6" -27, 318" NPT). Use cold
water supply only (hot water may cause scalding). Not intended to meet
ANSI 2358.1 -1 998- supplemental use only.

More Eye wash units:

Eye Wash Units (Sebastian Fixtures)

32 N. Wood Rd. - Camarillo, CA. 93010
Phone:805/484-1038 Fax:805/484-1030 Email:contact@calstainless.com

TOP

Home / About Us Product Index Darkroom Doors Photo Darkroom Design Drying Cabinets
E.M. Processor Sink Plumbing Photographic Sinks & Stainless Sinks

© 2006 California Stainless Manufacturing, Inc.
Web site design by dock.net 2002